Taps

Taps for hand tapping and machine tapping

For distributors, workshops and OEM buyers: this range covers hand taps turned with a tap wrench and machine taps driven in a chuck or tapping head, in metric coarse and fine pitches, UNC, UNF, NPT and BSP. The quotation is built from three answers: the thread, the hole type and the material being tapped.

Hand taps suit parts that cannot be mounted on a machine, or threads cut in stages through a deep hole. Machine taps run at spindle speed, so flute geometry matters more than the shank: it decides where the chip goes, and therefore whether the thread and the tool survive the operation.

Tool material follows the workpiece. HSS covers general steel and maintenance work. HSSE cobalt grades hold an edge longer in stainless and higher-alloy material, where work hardening and heat build-up shorten tool life quickly.

Machine taps
Spiral flute, spiral point and forming geometry
Tap and die sets
Matched taps and dies in one case
Round dies
External threads, hand and machine
Buying checklist
Thread and size reference before ordering

What to confirm before ordering a tap

Send the thread designation with the hole type and material, and we will confirm the geometry before quoting. You can also review the tap and die buying checklist or send a tap inquiry.

Home
News
Contact
Product